Gas Spring Dimensions Guide

Measure Extended Length, Compressed Length, And Stroke

Correct gas spring dimensions are essential when replacing an existing strut or designing a new OEM application. Engineers should measure center-to-center extended length, compressed length, stroke, rod diameter, tube diameter, end fitting type, and force rating before choosing a replacement or custom specification.

Use Measurements To Choose The Right Product Family

Once dimensions are known, browse lift gas springs for standard support, lockable gas springs for controlled positioning, or SS316 stainless steel gas springs for corrosion-prone environments. The force calculator and mounting guide can help confirm whether the measured size works with the application geometry.

Check Fittings, Brackets, And Clearance Before Production

End fittings change the installed length and pivot behavior of a gas spring. Ball sockets, clevis ends, blade ends, eyelets, brackets, and custom fittings should be checked through the full open and closed positions. The gas spring must not bottom out, over-extend, bind, or collide with surrounding parts during the motion cycle.

Send Complete Dimensions For Faster OEM Review

For a dimensional review, send application photos, extended length, compressed length, stroke, rod diameter, tube diameter, end fitting type, mounting point distance, opening angle, panel weight, force marking if available, working environment, and quantity. These details help LX Gas Spring match the correct product family and avoid trial-and-error samples.

Center-To-Center Measurement Is The Main Reference

When end fittings are installed, measure from the center of the pivot hole, ball socket, eyelet, or clevis pin at one end to the equivalent pivot center at the other end. Do not use the outside tip-to-tip length unless a drawing specifically defines that reference. If the fittings are removed, identify the thread size and thread-to-thread body length separately so the finished assembly length can be calculated correctly.

Relationship Between Extended Length, Compressed Length, And Stroke

For a simple reference, usable stroke is approximately the center-to-center extended length minus the center-to-center compressed length when the same fittings remain installed. The actual product drawing should still be used for production because guide length, internal stop allowance, threads, and fitting geometry can change the finished dimensions. Do not design the mechanism to force the gas spring against its internal stop.

Replacement Gas Spring Measurement Example

Suppose a removed gas spring measures 500 mm center-to-center when fully extended and 300 mm center-to-center when fully compressed. The nominal travel is 200 mm. Record that value together with the rod and tube diameters, both fitting types, thread sizes, printed Newton rating, mounting orientation, and photos of the open and closed mechanism. Matching only 500 mm is not enough to confirm fit or force.

Dimensional Checks Before Sample Approval

Install the sample in the real assembly and check full closure, desired opening angle, remaining stroke reserve, fitting articulation, bracket clearance, rod alignment, opening effort, closing effort, and any contact with nearby parts. For paired gas springs, confirm that both mounting positions are symmetrical and that the force ratings are matched. Production approval should follow the application test rather than catalogue dimensions alone.